On Facebook Since 8/11

Sizes and Prices Button

Nu Fresh, LLC

P.O.Box  272581 

Fort Collins, CO 80527

CustomerService @TechnoFresh.net

Ideas for Different Wash Schedules:

Please note that these ideas have been effective in the past.

However, the new formula has made a big difference in control.

You will end up using less TechnoFresh® than these suggest.

1/2 to 3/4 capful/ounce per load could be enough now. But, we are leaving the recommended amounts as they were for assured performance.

There has not been a single case where this new formula did not knock out the odor and gasket mold completely when all suggestions on this site are followed.

____________________________________

New Washing Machine

If you are getting a new machine and want to start out under control follow these steps:

Note: These instructions essentially kick start the control process.

Use TechnoFresh® in the first three loads at 3 capfuls per load.

Then use normally as needed.

Explanation:

Since you are going to get detergent film on the plumbing as soon as you use the machine, you should put down a coating that has a high concentration of TechnoFresh® in it.

That would be the most effective way of starting out using the machine.

Even if the machine had been used already, a couple of TechnoFresh® shock treatment flushes, should get you back to a clean enough surface for this to also work.

It seems the contamination level is affected more by idle time rather than loads run.

So try to do this treatment within 2-3 weeks of starting to use the machine.

Machines that are now in use

In most cases, your machine has been in use and has had a long time to get the nasties growing into all the nooks and crannies of the plumbing.

You have to do the complete TechnoFresh® Super Shock Treatment flush procedure to remove the build up of gunk.

After which you will fall into one of the categories below

____________________________________

If you do many loads every week, a couple of loads almost every day:

You should not need to use a lot of TechnoFresh®.
Start with a capful in every load until you get the odor under control
Then back off to one load twice a week( first load of the day)
Note how long it takes for the smell to return.
You now know your range of control, increase as necessary 

____________________________________

If you do 3 or less loads per week:

The machine will have a long time to sit and get stinky. You may need to add half an ounce of TechnoFresh® to every load for the best chance of success.
____________________________________

If you do more than 3 or 4 loads a week but you do them over 1 or 2 days
(with the machine sitting idle for most of the week):
 

Use TechnoFresh® in the first 2 or 3 loads of the week to get the stuff that grew during the week and then the last 2 loads of the week to suppress growth during the idle time for best chance of success

____________________________________

If the machine sits unused for longer than 7-10 days:

You probably will need to run an empty load with hot water to flush out the water that is in the plumbing before you start doing the laundry.

Use TechnoFresh® in the first 2 or 3 loads of the week to get the stuff that grew during the week and then the last 2 loads of the week to suppress growth during the idle time for best chance of success

Vacations:

A customer suggested that water with TechnoFresh® be added to the machine drum before leaving on vacation. I suggested one ounce in a gallon of water. Add one or two gallons of the mix to the machine drum directly. Close the door. This really should help a lot but no one has given feedback one way or another. So, I can't guarantee this will work. If you try it let me know how it worked....

____________________________________